How to Guide

Product Information
Applicable product:
Bath whirlpool with Massage Experience K-1110-M
Fixture:*
Bathing well:
Basin area, bottom 42″ (1067 mm) x 25-1/2″ (648
mm)
Basin area, top 63″ (1600 mm) x 31-1/2″ (800
mm)
Weight 160 lbs (72.6 kg)
To overflow:
Water depth to rim 19-1/4″ (489 mm)
Capacity 96 gal (363.4 L)
* Approximate measurements for comparison only.
Included component:
Cut-out template 1016369-7
Pump Heater V Hz A
1.5 kW 240 50/60 15
Required accessories:
Clearflo horizontal overflow bath drain K-7273
Required Electrical Service
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI) or Residual
Current Device (RCD):
Pump/control 220/240 V, 20 A, 50/60 Hz
Installation Notes
Install this product according to the installation guide.
Pump/piping protrudes beyond rim (see below).
Floor support under whirlpool must provide a minimum of 43
lbs/square foot (209 kg/square meter) loading.
Hot water supply should be 70% of capacity or greater.
Installations will vary.
Fixture conforms to CSA B45.5/IAPMO Z124. All dimensions
are nominal.
72" (1829 mm)
6" (152 mm)
7/16" (11 mm)
Ø 1-1/2"
No change in measurements
with drain shown. (K-7273)
46"
(1168 mm)
2-3/4" (70 mm) Max
Pump/Control Access
34" (864 mm) W x
15" (381 mm) H Min
23-3/16"
(589 mm)
22"
(559 mm)
1-3/16"
(30 mm)
1-3/8"
(35 mm)
23"
(584 mm)
3-15/16"
(100 mm)
12-3/16"
(310 mm)
6-3/8"
(162 mm)
Note:
Pump/Piping Protrudes Beyond Rim
Roughing-In
K-1110-M
PURIST
®
BATH WHIRLPOOL WITH MASSAGE EXPERIENCE
PURIST
®
BATH WHIRLPOOL WITH MASSAGE EXPERIENCE
1023257-1-
F