Use and Care Guide

Your Kohler Whirlpool
Components
Your new whirlpool is designed to stimulate, invigorate, and energize your body with comforting
hydro-massage therapy. The whirlpool consists of the following components:
•
Bath - acts as a reservoir for water, and provides a location for the hydro-massage action.
•
Air Actuator Control - located within easy reach, the air actuator control turns the whilrpool on and
off through the activation of a reliable sensing device.
•
Pump Motor - provides quiet power to circulate the water and create the soothing hydro-massage
action.
•
Adjustable Jets - positioned to optimize their hydro-massage effect, the jets allow you to adjust the
air and water flow and control the flow direction as you desire.
•
Heater (-H models only) - designed to automatically help maintain the temperature of the water up
to 104°F (40°C) to enhance your hydro-massage experience. The heater turns on automatically when
the whirlpool is running, and turns off when the pump motor is turned off.
•
Timer Kit (available as an optional accessory) - automatically stops the pump after about 20
minutes of continuous whirlpool operation.
•
Integral or Removable Apron (available on select models) - designed to complement the style and
contours of your whirlpool. The whirlpool apron also provides easy front side access to the pump
and controls in case servicing is necessary.
Operation
Position the jet nozzles to face down toward the basin. Turn the jet trim rings fully
counterclockwise.
NOTE: The water temperature in the whirlpool should never exceed 104°F (40°C).
Close the drain, then fill the whirlpool to a level at least 2” (5.1 cm) above the top of the highest jet.
Use your hand to test the water temperature for comfort and safety, then carefully enter the basin.
Press the air actuator to turn on the whirlpool.
Adjust the jets for optimum air/water mixture. Turn the jet trim rings clockwise to reduce the flow
or counterclockwise to increase the flow. Position the jet nozzles to direct the water flow as desired
to maximize your hydro-massage experience.
Press the air actuator a second time to turn off the whirlpool.
Carefully exit the basin, then open the drain to empty the whirlpool.
NOTE: If the whirlpool does not function properly, please refer to the ″Troubleshooting″ section.
Fill with water at least 2" (5.1 cm)
above the highest jet.
Turn the jet trim ring
clockwise to
decrease the flow.
Position the jet
nozzles to direct
the water flow as
desired.
Turn the jet trim ring counterclockwise
to increase the flow.
Press the air switch to turn the
whirlpool on or off.
1010997-5-H 4 Kohler Co.