Dimensions Guide

Technical Information
Fixture*:
Bathing well:
Basin area, bottom 55″ (139.7 cm) x 23-1/4″ (59.1 cm)
Basin area, top 64″ 162.6 cm) x 32″ (81.3 cm)
Weight 132 lbs (60 kg)
To overflow:
Water depth 15″ (38.1 cm)
Capacity 78.5 gal (297 L)
* Approximate measurements for comparison only.
Pump: V Hz A
1-speed 120 60 7.5
Minimum access panel pump/control:
20″ (50.8 cm) W x 15″ (38.1 cm) H required
Required Electrical Service
Dedicated circuit required, protected with a Class A
Ground-Fault Circuit-Interrupter (GFCI):
Pump/control 120 V, 15 A, 60 Hz
Locate the outlet behind the whirlpool and within 24″
(61 cm) of the pump.
Installation Notes
Install this product according to the installation guide.
Floor support under the whirlpool must provide for a minimum
of 39 lbs/square foot (189 kg/square meter) loading.
If installing a rim-mount faucet, make sure there is no
interference with the drain overflow and circulating system
before drilling any holes. Consult local and national codes for
minimum air gap requirements if installing a spout on the
faucet deck.
72" (182.9 cm)
42" (106.7 cm)
1-1/2" OD
3/8" (1 cm)
21"
(53.3 cm)
2-7/8" (7.3 cm)
3" (7.6 cm)
Recommended faucet area
No change in measurements if connected with
drain illustrated. (K-11677 or K-11677M)
3-1/2"
(8.9 cm)
1-1/4"
(3.2 cm)
21" (53.3 cm)
1-1/4" (3.2 cm)
1-1/4"
(3.2 cm)
Tile Flange
Detail
11-1/16" (28.1 cm)
3-3/4"
(9.5 cm)
Product Diagram
WINDWARD
®
WINDWARD
®
BATH WHIRLPOOL WITH INTEGRAL APRON
Page2of2
1047224-4-
C