How to Guide

Product Information
Applicable product:
Bath whirlpool – drop-in K-1146
Fixture*:
Bathing well:
Basin area, bottom 46″ (1168 mm) x 19″ (483 mm)
Basin area, top 55″ (1397 mm) x 29″ (737 mm)
Weight 56 lbs (25.4 kg)
To overflow:
Water depth 14″ (356 mm)
Capacity 54 gal (204.4 L)
* Approximate measurements for comparison only.
Pump: V Hz A
1-speed 120 60 7.5
Included components:
Cut-out template 114859-7
Required Electrical Service
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI):
Pump/control 120 V, 15 A, 60 Hz
Locate the outlet behind the whirlpool and within 24”
(610 mm) of the pump.
Installation Notes
Install this product according to the installation guide.
Floor support under whirlpool must provide for a minimum of
30 lbs/square foot (148 kg/square meter) loading.
The suction line extends 1″ (25 mm) beyond the edge of the
rim. The pump base extends 1-1/8″ (29 mm) beyond the edge
of the rim. Modify the framing as needed.
A minimum access panel is required as illustrated. This
should be 20″ (508 mm) wide and 15″ (381 mm) high. Locate
the access panel at the pump location.
This fixture conforms to ANSI Standard Z124.1.2. All
dimensions are nominal.
Drop-In
Rim Detail
1" (25 mm)
1-1/2" OD
8" (203 mm)
60" (1524 mm)
3" (76 mm)
2-7/8" (73 mm)
3/8" (10 mm)
40" (1016 mm)
Cut-Out Detail
Symmetrical About C
L
Drain End
1-1/4" (32 mm)
9" (229 mm)
5" (127 mm)
4" (102 mm)
1" (25 mm)
5/8" (16 mm)
10" (254 mm)
20" (508 mm)
26" (660 mm)
29" (737 mm)
29-3/4" (756 mm)
28" (711 mm)
20" (508 mm)
8" (203 mm)
6"(152 mm)
4"
(102 mm)
1"
(25 mm)
10" (254 mm)
No change in measurements if connected with
drain illustrated. (K-11677 or K-11677M)
20"
(508 mm)
3-1/8"
(79 mm)
2-1/2"
(64 mm)
Required
Pump/Control
Access
17-5/8"
(448 mm)
16-1/8"
(410 mm)
1-1/2"
(38 mm)
Roughing-In
K-1146
PROFLEX
®
6040
BATH WHIRLPOOL
PROFLEX
®
6040 BATH WHIRLPOOL
1013790-1-
E