How to Guide

Product Information
Applicable products:
Bath whirlpool with integral apron –
left drain
K-1224-LA
Bath whirlpool with integral apron –
right drain
K-1224-RA
Fixture*:
Basin area:
Bathing well, bottom 48″ (1219 mm) x 24″ (610 mm)
Bathing well, top 59″ (1499 mm) x 30″ (762 mm)
Weight 110 lbs (49.9 kg)
To overflow:
Water depth 14″ (356 mm)
Capacity 67 gal (254 L)
* Approximate measurements for comparison only.
Pump V Hz A
1-speed 120 60 7.5
Required Electrical Service
Dedicated circuit required, protected with a Class A
Ground-Fault Circuit-Interrupter (GFCI).
Pump/control 120 V, 15A, 60 Hz
Locate the outlet behind the whirlpool and within 24″
(610 mm) of the pump.
Installation Notes
Install this product according to the installation guide.
Floor support under whirlpool must provide for a minimum of
42 lbs/square foot (205 kg/square meter).
If installing a rim-mount faucet, make sure there is no
interference with the drain overflow before drilling any holes.
Consult local and national codes for minimum air gap
requirements if installing a spout on the faucet deck.
Fixture conforms to ANSI Standard Z124.1.2. All dimensions
are nominal.
Recommended faucet area.
No change in measurements with drain
shown. (K-7161-AF or K-7161M-AF)
1-1/4"
(32 mm)
1/2" R.
(13 mm) Max
Integral
Flange Detail
36" (914 mm)
Ø 1-1/2"
20"
(508 mm)
1" (25 mm)
2-7/8"
(73 mm)
3"
(76 mm)
3-1/2"
(89 mm)
66" (1676 mm)
8-11/16"
(221 mm)
1-11/16"
(43 mm)
18"
(457 mm)
Roughing-In
K-1224-LA, K-1224-RA
MARIPOSA
®
BATH WHIRLPOOL WITH INTEGRAL APRON
MARIPOSA
®
BATH WHIRLPOOL WITH INTEGRAL APRON
1038376-1-
D