How to Guide

Product Information
Applicable product:
Bath and shower trim – cross handle K-T16233-3
Bath and shower trim – lever handle K-T16233-4
Shower trim only – cross handle K-T16234-3
Shower trim only – lever handle K-T16234-4
Valve trim – cross handle K-T16235-3
Valve trim – lever handle K-T16235-4
Bath spout K-16246
Required accessories:
Rite-Temp
®
valve OR K-304-*
HiFlow Rite-Temp valve with stops OR K-2971-KS
Rite-Temp valve with diverter OR K-11748-K
Rite-Temp valve with diverter and stops K-11748-KS
* For a complete listing of all the Rite-Temp valves, refer
to the K-304-* Specification Sheet or Roughing-In Sheet.
Optional accessories:
HiFlow Rite-Temp
®
thin wall installation kit 88526
Installation Notes
Install this product according to the installation guide.
NOTICE: Risk of product damage. Long screws, for
installing trim, can damage the K-2971-KS valve. Consult the
trim installation guide to verify if the thin wall installation kit
(88526) is needed.
Avoid cross-flow conditions. Do not install shut-off device on
either valve outlet.
Cap shower outlet if deck-mount spout, diverter, or
handshower is connected to spout outlet.
Install straight pipe or tube drop of 7″ (17.8 cm) to 18″
(45.7 cm) with single elbow between the valve and wall-mount
spout.
10" (25.4 cm)
to Spout
(Bath Only)
2-1/8"
(5.4 cm)
10-5/16"
(26.2 cm)
3-9/16"
(9 cm)
7-3/16"
(18.3 cm)
For 1/2" NPT spout, pipe must
extend 7/16" (1.1 cm) beyond
finished wall.
3-3/16"
(8.1 cm)
5-1/2"
(14 cm)
48" (121.9 cm)
to Floor
(Shower Only)
72" (182.9 cm)
78" (198.1 cm)
to Floor (Typical)
6-1/2"
(16.5 cm)
6-1/2"
(16.5 cm)
4"
(10.2 cm)
1/2" NPT
6-13/16" (17.3 cm)
Top of Bath
Roughing-In
K-T16233, K-T16234, K-T16235, K-T16246
MARGAUX
®
RITE-TEMP
®
BATH AND SHOWER TRIM
MARGAUX
®
RITE-TEMP
®
BATH AND SHOWER TRIM
1059598-1-
D