Installation Guide

Preparation (cont.)
Carefully remove the shroud and lavatory from the area.
2. Install the Lavatory
Draw a line connecting the two upper anchoring hole marks on the
wall.
Drill a 1/4” mounting holes at the marked lavatory mounting
locations on the finished wall.
Install the two upper angle brackets to the wall so the bracket holes
are 5-1/4” (13.3cm) apart.
Install the faucet and drain to the lavatory according to the
manufacturer’s instructions.
CAUTION: Risk of product damage. Do not overtighten the lag
bolts. Overtightening may damage the product.
Carefully set the lavatory on the hanger. Level the lavatory, and
carefully secure the lavatory to the wall with lag bolts and washers.
Tighten until snug.
Connect and tighten the trap to the drain, and complete the water
supply connections to the faucet according to the instructions
packed with the faucet.
Apply six self-adhesive gaskets to the top of the shroud as shown.
1015627-2-B 4 Kohler Co.