Installation Guide

3. Install the Suction Cover
WARNING: Risk of personal injury or death. Never operate the
whirlpool bath without the suction cover in place. Doing so may
result in serious injury or death. If your whirlpool does not have
the suction cover installed, install the necessary parts prior to
using your whirlpool.
NOTE: The suction cover may already be installed on your
whirlpool.
Insert the screw through the suction cover and into the threaded
center hole of the suction fitting on your whirlpool. Position the
suction cover with the Kohler logo facing upward.
Tighten the screw until the sides of the cover are snug against the
wall of the whirlpool. Do not overtighten.
Press the plug (if supplied) into the recessed hole on the cover.
Plug (Plastic
Trim Only)
Screw
Suction Cover
Kohler Co. 5 1025430-2-B