Instructions / Assembly

TT-1297 9/11 3
Installation Procedure
1. Remove the generator set from service.
1.1 Place the generator set master switch in the OFF
position.
1.2 Disconnect the power to the battery charger, if
equipped.
1.3 Disconnect the generator set engine starting
battery(ies), negative (--) lead first.
1.4 Remove the generator set enclosure door and
roof to gain full access to the engine air cleaner.
2. Remove the air cleaner assembly. See
Figure 2.
2.1 Loosen the air cleaner cover retaining knob and
remove the cover.
2.2 Remove the wing nut and the element cover.
2.3 Remove the air cleaner element and foam
precleaner.
2.4 Remove the four screws that attach the air cleaner
bracket and base to the carburetor assembly.
Remove the bracket and base.
3. Prepare to install the heater.
3.1 Remove and discard the air cleaner spacer and
two gaskets. See Figure 3.
3.2 Remove the rubber crankcase breather hose.
Save the clamp to reuse later. See Figure 3
.
1
2
3
4
5
6
5868g10
1. Cover knob
2. Air cleaner cover
3. Wing nut
4. Element cover
5. Foam precleaner and air cleaner element
6. Bracket
7. Air cleaner base
7
Figure 2 Air Cleaner Components
2
326sd2
1. Crankcase breather hose (reuse)
2. Spacer (discard)
3. Two gaskets (discard)
3
1
Figure 3 Crankcase Breather Hose, Air Cleaner
Spacer, and Gaskets