Specification Sheet

No change in measurements if connected
Notes
Required Electrical Service
Measure your actual product for rough-in details.
Two dedicated circuits required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI) or Residual Current Device
(RCD).
Install this product according to the installation
instructions.
The hot water supply should be 70% of the
capacity of the bath or greater. Installations will
vary.
120 V, 15 A, 60 HzPump:
120 V, 15 A, 60 HzHeater:
Technical Information
Provide one grounded electrical outlet within 24"
(610 mm) of each component.
All product dimensions are nominal.
3-Wall AlcoveInstallation:
If installing a rim-mount faucet, make sure there
is no interference with the drain overflow and
RightDrain location:
55" x 23-1/4" (1397 mm x 591 mm)Basin area, bottom:
circulating system before drilling any holes.
64" x 32" (1626 mm x 813 mm)Basin area, top:
Consult local and national codes for minimum air
gap requirements if installing a spout on the
faucet deck.
149 lbs (67.6 kg)Weight:
39 lbs/ft² (190.4 kg/m²)Minimum floor load:
15" (381 mm)Water depth:
78.5 gal (297.2 L)Water capacity:
Pump: 120 V, 7.5 A, 60 Hz
Heater: 120 V, 12.5 A, 60 Hz, 1500 W
Electrical component
rating:
SinglePump speed:
3-1/16" (78 mm)Minimum flat for door:
USA/Canada: 1-800-4KOHLER (1-800-456-4537)
Kohler Co. reserves the right to make revisions without notice to product specifications.
For the most current Specification Sheet, go to www.kohler.com.
3-7-2017 04:37
Windward
®
6' Whirlpool Bath
K-1114-HR