Rough-In Guide

Product Information
Applicable product:
Drop-in bath whirlpool with heater K-1122-H
Fixture*:
Bathing well
Basin area,
bottom
45-1/8″ (114.6 cm) x 19-11/16″ (50 cm)
Basin area, top 52-3/4″ (134 cm) x 25-5/16″ (64.3 cm)
Weight 110 lbs (50 kg)
To overflow
Water depth 15″ (38.1 cm)
Capacity 58 gal (219.5 L)
* Approximate measurements for comparison only.
Drop-in cutout 58-1/2″ (148.6 cm) x 30-1/2″ (77.5 cm)
Pump: V Hz A
1-speed 120 60 7
Heater: kW V Hz A
1.5 120 60 12.5
Pump is supplied with 24″ (61 cm) grounding-type plug-in
cord.
Required accessories:
Clearflo slotted overflow brass bath drain OR K-7271
Clearflo slotted overflow bath drain – PVC pipe K-7272
Required Electrical Service
Two dedicated circuits required, each protected with
Class A Ground-Fault Circuit-Interrupter (GFCI):
Pump/control 120 V, 15 A, 60 Hz
Heater 120 V, 15 A, 60 Hz
Installation Notes
Install this product according to the installation guide.
Floor support under this product must provide for a minimum
of 46 lbs/square foot (227 kg/square meter) loading.
This product is designed for drop-in installation only. It is not
suited for use in a three-wall alcove with an overhead shower.
The hot water supply should be 70% of the capacity of the
bath or greater. Installations will vary.
Will comply with ADA when installed per Section 607
Bathtubs of the Act.
Fixture conforms to ANSI Standard Z124.1.2. All dimensions
are nominal.
32" (81.3 cm)
60" (152.4 cm)
1-1/2"
Bath Drain
3/4" (1.9 cm)
16"
(40.6 cm)
1-1/4"
(3.2 cm)
2-1/2"
(6.4 cm)
19"
(48.3 cm)
Drop-in Rim Detail
No change in measurements if connected
with drain illustrated. (K-7272)
11-1/4"
(28.6 cm)
Pump/Control Access
20" (50.8 cm) W x 15" (38.1 cm) H
1-1/2"
(3.8 cm)
4-1/8"
(10.5 cm)
Roughing-In
K-1122-H
ARCHER
TM
5’ (1.5 m) BATH WHIRLPOOL WITH HEATER
ARCHERTM 5’ (1.5 m) BATH WHIRLPOOL WITH HEATER
1071357-1-
E