Dimensions Guide

18"
Notes
Required Electrical Service
Measure your actual product for rough-in details.
One dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI) or Residual Current Device
(RCD).
Install this product according to the installation
instructions.
The hot water supply should be 70% of the
capacity of the bath or greater. Installations will
vary.
220-240 V, 20 A, 50/60 HzBlower, Pump,
Heater:
Technical Information
This unit is not intended for flush-mount apron
installation.
All product dimensions are nominal.
3-Wall AlcoveInstallation:
IMPORTANT! Dry fit the drain assembly prior to
installing the bath. The bath cannot be installed
with all drain components attached.
RightDrain location:
42-7/16" x 20" (1078 mm x 508 mm)Basin area, bottom:
54-5/16" x 24-1/4" (1380 mm x 616 mm)Basin area, top:
The pump base extends 10-1/4" (260 mm)
beyond the edge of the rim. Modify the framing
as needed.
157 lbs (71.2 kg)Weight:
53.9 lbs/ft² (263.2 kg/m²)Minimum floor load:
15-1/8" (384 mm)Water depth:
59.8 gal (226.4 L)Water capacity:
Blower: 220-240 V, 3 A, 50/60 Hz
Pump: 220-240 V, 11 A, 50/60 Hz
Heater: 220-240 V, 50/60 Hz, 1500 W
Electrical component
rating:
1-15/16" (49 mm)Minimum flat for door:
1-800-4KOHLER (1-800-456-4537)
Kohler Co. reserves the right to make revisions without notice to product specifications.
For the most current Specification Sheet, go to www.kohler.com.
9-28-2018 08:43
Underscore
®
Rectangle
5' BubbleMassage
™
Whirlpool Bath
K-1167-XH2GR