Installation Guide

Clean the Screen Washer
Use a clean wrench to remove the showerhead from the shower
arm; be careful not to mar the finish.
Use a thin bladed screwdriver to carefully pry up the edge of the
screen washer. Remove and clean the screen washer.
NOTE: Do not attempt to remove the flow control.
Reinstall the screen washer with the tapered end out.
Apply sealant tape to the threads of the shower arm.
Reinstall the showerhead.
Care and Cleaning
For best results, keep the following in mind when caring for your
KOHLER product:
•
Use a mild detergent such as liquid dishwashing soap and warm
water for cleaning. Do not use abrasive cleaners that may scratch
or dull the surface.
•
Carefully read the cleaner product label to ensure the cleaner is
safe for use on the material.
•
Always test your cleaning solution on an inconspicuous area
before applying to the entire surface.
•
Do not allow cleaners to sit or soak on the surface.
Screen Washer
Showerhead
Apply thread sealant.
Inlet
Kohler Co. 5 1141989-2-G