Rough In Guide

Product Information
Applicable product:
6’ Freestanding BubbleMassage
bath
K-14037-G
Fixture*:
Bathing well
Basin area,
bottom
46-3/4″ (1187 mm) x
21-5/8″ (549 mm)
Basin area, top 69-15/16″ (1776 mm) x
34-3/8″ (873 mm)
Weight 130 lbs (59 kg)
To overflow
Water depth 16-1/2″ (421 mm)
Capacity 71 gal (268.8 L)
* Approximate measurements for comparison only.
Blower
motor:
Heater V Hz A
300 W 120 60 5
Required accessories:
Bath drain K-7219
Recommended spouts and spout locations*:
Area A – floor-mount
installation
K-994 OR K-10129
Area B – ceiling-mount
installation
K-922 OR K-923
*Refer to shaded areas in product diagram for
recommended installation area locations.
Required Electrical Service
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI):
Blower motor: 120 V, 15 A, 60 Hz
Blower motor is supplied with a 24″ (610 mm)
grounding-type plug-in cord.
Installation Notes
Install this product according to the installation guide.
Floor support under bath must provide for a minimum of 41.5
lbs/square foot (202.8 kg/square meter) loading.
BubbleMassage blower requires remote mounting.
Fixture conforms to CSA B45.5/IAPMO Z124. All dimensions
are nominal.
2-1/4" (57 mm)
1-1/2" Bath Drain
2-1/2"
(64 mm)
36"
(914 mm)
18"
(457 mm)
A
B
24-1/8"
(613 mm)
21-5/8"
(549 mm)
72" (1829 mm)
36"
(914 mm)
No change in measurements if connected
with drain illustrated. (K-7219)
1-5/8" (35 mm)
Roughing-In
K-14037-G
ESCALE
®
FREESTANDING BUBBLEMASSAGETM BATH
ESCALE
®
FREESTANDING BUBBLEMASSAGETM BATH
1207550-1-
A