Installation Guide

1. Handle Valve Installation
Turn each valve to the closed position.
Place a spline adapter about halfway onto each valve stem.
Partially install a handle onto each spline adapter, and check the
handle alignment.
For further alignment, remove the handle and reposition the
spline adapter until the handle alignment is correct.
Secure each handle to the valve stem with the supplied standard
screw and cap or the vandal resistant screw and red (hot side) or
blue (cold side) cap.
Standard Cap
Standard
Screw
Red or
Blue Cap
Vandal-Resistant
Screw
Spline
Adapter
Valve
Stem
Escutcheon
Handle
Kohler Co. 3 113136-2-AB