Installation Guide

2. Install the Lavatory
Install the faucet and drain to the lavatory according to the
manufacturer’s instructions.
Installation With Hanger
Temporarily position the lavatory on the hanger, and level. Use a
pencil to mark the anchoring hole locations on the finished wall.
Remove the lavatory.
Drill 1/4” mounting holes at the marked locations on the wall.
CAUTION: Risk of product damage. Do not overtighten the
hardware. Overtightening may damage the product.
Position the lavatory on the hanger, and level. Use 3/8″ lag bolts
and washers (not provided) to secure the lavatory to the finished
wall and backing material.
Connect and tighten the trap to the drain, and complete the water
supply connections to the faucet according to the instructions
packed with the faucet.
Run water into the lavatory and check for leaks.
Clean up with a non-abrasive cleaner.
Installation With Concealed Arm Carrier
CAUTION: Risk of product damage. Do not overtighten the
hardware. Overtightening may damage the product.
1018370-2-B 4 Kohler Co.