Installation Guide

Install the Lavatory (cont.)
Slide the lavatory completely onto the carrier arms. Adjust the
level of the lavatory by turning the front and rear carrier arm
screws in or out as needed. The lavatory should not rock after it
has been leveled.
Carefully tighten the toggle screws until the lavatory is securely
held in place.
Connect and tighten the trap to the drain, and complete the water
supply connections to the faucet according to the instructions
packed with the faucet.
Run water into the lavatory and check for leaks.
Clean up with a non-abrasive cleaner.
Kohler Co. 5 1018370-2-B