Installation Guide

2. Install the Lavatory
NOTE: Fastening devices other than hanger bolts may be used to
mount the lavatory. Ensure the fastening devices are of sufficient
size and strength.
Install the hanger bolts to the backing material. The hanger bolts
must extend 1″ (2.5 cm) between the cap nuts and the finished
wall.
Install the faucet and drain to the lavatory according to the
manufacturer’s instructions.
CAUTION: Risk of product damage. Do not overtighten the
wood screw. Overtightening may damage the product.
Move the pedestal over the drilled hole in the floor. Secure the
pedestal to the floor with the wood screw and washer.
Carefully set the lavatory on the pedestal so the hanger bolts
extend through the lavatory anchoring holes.
CAUTION: Risk of product damage. Do not overtighten the cap
nuts. Overtightening may damage the product.
Install the cap nuts and washers to the hanger bolts. Level the
lavatory, then carefully tighten the cap nuts until snug.
Connect and tighten the trap to the drain.
Complete the water supply connections to the faucet according to
the instructions packed with the faucet.
Install faucet and drain.
Secure pedestal with the
wood screw and washer.
Install cap nuts
and washers.
Pedestal
Finished Wall
Hanger
Bolts
Kohler Co. 5 1016179-2-D