Installation Guide

3
Kohler Co., Kohler, WI U.S.A.
1010427-2-
A
 Drill a 1/4” (6mm) mounting hole at
the mark on the floor, then drill two
1/4” (6mm) hanger bolt holes at the
marks on the wall.
 Mount hanger bolts to the wall so
approximately 1-1/4” (3.2cm) of
each bolt remains exposed.
NOTE: Other fastening devices of
sufficient size and strength may also be
used.
Finish Wall
Hanger
Bolts
 Install the faucet and drain to the
lavatory according to the
manufacturer’s instructions.
NOTE: Do not fully tighten slip-joint
drain connections at this time.
 Position the pedestal mounting
hole over the hole in the floor.
 Secure the pedestal to the floor
with the wood screw and washer.
Tighten the wood screw until it is
snug.
CAUTION: Risk of product
damage
. Do not overtighten.
Overtightening may cause damage
to the product.
Pedestal
Wood Screw
Washer