Installation Guide

2. Install the Lavatory
Drill 1/4″ mounting holes at the marked locations on the finished
wall and the floor.
NOTE: Fastening devices other than hanger bolts may be used to
mount the lavatory. Ensure the fastening devices are of sufficient
size and strength.
Install the hanger bolts to the backing material so they extend 1″
(2.5 cm) beyond the finished wall.
Install the faucet and drain to the lavatory according to the
manufacturer’s instructions.
Move the pedestal over the drilled hole in the floor. Secure the
pedestal to the floor with the wood screw and washer.
Carefully set the lavatory onto the pedestal so the hanger bolts
extend through the lavatory anchoring holes.
CAUTION: Risk of product damage. Do not overtighten the cap
nuts. Overtightening may damage the product.
Install the cap nuts and washers to the hanger bolts. Level the
lavatory, then carefully tighten the cap nuts until snug.
Washer
Pedestal
Install faucet
and drain.
Cap Nut
Apply
adhesive
gaskets.
Pedestal and Lavatory Placement
Finished Wall
Hanger
Bolts
Mark anchoring
holes.
10-1/2"
(26.7 cm)
9-1/2"
(24.1 cm)
Wood Screw
Washer
Kohler Co. 5 1063452-2-B