Installation Guide

1. Install the Lavatory
CAUTION: Risk of product damage. Do not overtighten
drain connection.
CAUTION: Risk of product damage. Ensure the foam gasket
provided with the lavatory is properly positioned under the
drain flange.
IMPORTANT! The drain must be installed using the foam gasket
and O-ring provided with the lavatory. Do not use the gasket
supplied with the drain.
Position the lavatory on the countertop at the installation location.
Trace the lavatory drain hole onto the countertop.
Remove the lavatory and set aside.
Drill a 1-5/8″ (4.1 cm) hole, at the marked location.
NOTE: For K-2369 only: The white foam pad provided may be
placed on the countertop to enhance the color of the lavatory. If you
are planning to install your lavatory with the foam pad, use care to
not damage or mark-up the pad.
Discard gasket
supplied with the drain.
Washer
Roll the O-ring onto the
drain body and seat into the
underside of the lavatory.
Nut
Drain Body
Foam Gasket
(supplied with lavatory)
O-Ring
(supplied with lavatory)
1-5/8" (4.1 cm)
Drain Hole
Optional
Foam Pad
K-2369 Only:
Kohler Co. 3 1095015-2-C