Installation Guide

6. Recommended Hardware Placement
Measure and mark the dimensions for the hardware as shown
above.
Drill a 3/16″ (21 mm) pilot hole at each marking.
Drill a finished hole to size.
Insert a screw through each hole. Thread the knob onto the screw.
24” Vanity Installation
From the back side of the door, insert the screw through the
predrilled hole.
Thread the knob onto the screw. Tighten securely.
Repeat for the drawer.
K-5288: 6-1/16" (154 mm)
K-5289: 4-9/16" (116 mm)
4-3/4"
(121 mm)
1"
(25 mm)
Kohler Co. 9 1267640-2-A