Installation Guide

Operating the Whirlpool System
NOTE: This is a combination whirlpool bath with airjets. For information on using the air features, refer
to the ″Operating the Air System″ section.
NOTE: A built-in heater helps maintain the water temperature when the whirlpool is running. If the
temperature exceeds 104°F (40°C), the heater will turn off.
Start/Stop the Whirlpool Jets
Position the jet nozzles downward and turn the jet trim rings fully counterclockwise.
Fill the bath at least 2″ (51 mm) above the highest whirlpool jets.
Use your hand to test the water temperature before entering the bath.
Press the power icon to turn the whirlpool on. The whirlpool will start at medium flow, and the
heater will turn on automatically.
Press the power icon a second time to turn the whirlpool off.
NOTE: A built-in timer automatically stops the pump and motor after approximately 20 minutes of
operation.
Adjust Water Flow and Temperature
Adjust the water flow by pressing the up or down icon. An indicator bar in the center of the keypad
shows the water flow volume.
Adjust each jet for optimum air/water mixture. Turn the jet trim clockwise to reduce air flow, or
counterclockwise to increase air flow.
Press the heater icon to turn the heater off and on.
When illuminated, the heat indicator light shows that the water temperature will be maintained up
to 104°F (40°C).
Heater
On/Off
Heater Indicator Light
Up
Indicator Bar - Shows
Water Flow Volume
Down
Power
On/Off
Turn jet trim clockwise
to decrease the flow.
Turn jet trim
counterclockwise
to increase the flow.
Kohler Co. 11 1208018-2-D