Installation Guide

Operating the Air System
NOTE: This is a combination whirlpool bath with airjets. For information on using the whirlpool features,
refer to the ″Operating the Whirlpool System″ section.
Start the Airjets
Fill the bath at least 2″ (51 mm) above the highest whirlpool jets to provide adequate water supply
for the air system.
Use your hand to test the water temperature before entering the bath.
Press the power icon on the user keypad to start the air system.
Adjust the air flow rate by pressing the up or down icon.
Select an Air Flow Mode
Rotate the outer ring on the keypad to select a mode.
Press the ″OK″ icon to activate the mode.
To turn a mode off, rotate the outer ring until the icon flashes green, then press the ″OK″ icon.
The icon will turn blue, indicating the mode is off.
Stop the Airjets
Press the power icon to turn the air system off.
Press the power icon to turn the air system off.
Manual Purge Cycle (Optional)
NOTE: Follow these steps to manually purge residual water from the air system.
After stopping the air system and draining the bath, rotate the outer ring to the purge icon.
When the purge icon flashes blue, press the ″OK″ icon.
The purge icon flashes green as the manual purge begins. The air system operates at low speed to
blow residual water out of the air harness.
After 2 minutes, the air system stops automatically.
Air Flow Mode
Activates Mode Selected
Power On/Off
Indicator Bar
Decrease Flow or Surge
Increase Flow or Surge
Zone 1
Zone 2
Zone 3
Surge Mode
Purge Mode
Chromatherapy Cycle (if provided)
Chromatherapy Specific
Color (if provided)
Rotate Outer Ring to
Access Desired Mode
1208018-2-D 12 Kohler Co.