Installation Guide

3. Self-Rimming Installation
CAUTION: Risk of personal injury or property damage. Cast
iron sinks are very heavy. Get help lifting the sink into place.
Cut out the opening by carefully following the pencil line traced
from the template.
Drill the faucet holes, and install the faucet to the countertop
according to the faucet manufacturer’s instructions.
Install the strainer to the sink according to the manufacturer’s
instructions.
Clean the countertop.
Carefully position the sink into the countertop opening so the
“Kohler” logo is to the back.
Verify the fit and position. Make any needed adjustments.
Apply a thin continuous bead of sealant around the sink edges.
Immediately wipe away any excess sealant, and fill any voids as
needed.
Verify that the sink has not moved out of position.
Allow the sealant to cure at least 30 minutes before proceeding.
Install the garbage disposal, if desired, according to the
manufacturer’s instructions.
Connect and tighten the trap to the drain assemblies, and
complete the water supply connections to the faucet according to
the instructions packed with the faucet.
Run water into the sink and check for leaks.
Clean up with a non-abrasive cleaner.
Sealant
1019947-2-C 8 Kohler Co.