Use and Care Manual

Shower Doors
For best results, keep the following in mind when caring for your KOHLER®
product:
Always test your cleaning solution on an inconspicuous area before applying to the entire surface.
Wipe surfaces clean and rinse completely with water immediately after applying cleaner. Rinse and dry any overspray
that lands on nearby surfaces.
Do not allow cleaner to soak.
Use a soft, dampened sponge or cloth. Never use an abrasive material such as a brush or scouring pad to clean
surfaces.
For warranty information call 1-800-4KOHLER (1-800-456-4537).
* Success with cleaners and procedures is dependent upon such factors as the hardness and temperature of the
water, using exact measurements of ingredients, changes in cleaning formulas and the condition of the product being
cleaned. Since there are variations within these factors, Kohler cannot guarantee the effectiveness of the formulas.
_____________________________________________________________________________________________
CleanCoat Technology
The use of abrasive cleaners is not recommended for glass doors treated with CleanCoat®. Simply wipe down
CleanCoat doors regularly with a soft cloth and water or a squeegee to keep the glass looking clean.
NOTE: The “Products to Consider” may be used on CleanCoat glass, but are not necessary.
Use a shower squeegee to clean glass doors after showering to help prevent water spots.
To avoid soap deposits or lime buildup in hard water areas, wipe the door dry after each use.

Summary of content (2 pages)