Installation Guide

Installation

If present, remove and discard the protective plastic cap from

ﬂange.

Remove the nut, friction washer, and seal from the drain body.

Apply a bead of plumbers putty or other sealant around the

underside of the ﬂange according to the sealant manufacturer’s

instructions.

Insert the drain assembly into the drain hole and press into place.

NOTE: For K-7127: A thin seal and a thick seal are provided with

your drain. Use the thin seal when installing the drain to lavatories

with a thick wall, such as vitreous china or cast iron. Use the thick

seal when installing the drain to lavatories with a thin wall, such as

stainless steel or copper.

Slide the seal (tapered side up) and the friction washer onto the

drain body.

NOTE: Do not to rotate the drain while tightening the nut.

Thread the nut up the drain body until snug against the

underside of the lavatory.

Using an adjustable wrench, tighten the nut. Do not overtighten.

Remove any excess putty or sealant.

Connect the P-trap (not provided) to the drain body.

Friction

Washer

Flange

Stopper

Drain

Body

Nut

Seal

Kohler Co. 3 1052943-2-C