Installation Guide

1010455-2-A

Kohler Co.

ATTACHED LIFT ROD ASSEMBLY MODELS: Position

the lift rod assembly directly on the drain stopper. Adjust

the assembly length so the alignment ribs of the overflow

hood line up with the top edge of the overflow hole in the

bath. Refer to the illustration.

Insert the lift rod assembly into the overflow ell. Tighten

the overflow hood to the overflow ell with the two screws

provided.

NOTE: For installations where the overflow hood will be

exposed to high volumes of direct water spray, apply

silicone sealant around the overflow hood.

Fig. #9

Alignment

Ribs

Overflow

Hole

Assemble the handle to the overflow hood with the screw

provided. It may be necessary to adjust the handle to the

desired position.

Fig. #10

Handle

Overflow

Hood

Insert the drain stopper into the drain ell.

Fig. #11

The drain stopper should rise approximately 3/8” (1cm)

above the strainer.      

         

       

 

Fig. #12

Nut

Stopper

Toggle