Installation Guide

ManualsBrandsKOHLER ManualsPlumbing ProductClearflo 2 in. Adjustable Pop-Up Drain



112035-2-AA (A)

1998 Kohler Co.





 

BEFORE YOU BEGIN

HOW TO USE THESE INSTRUCTIONS

Please read these instructions carefully to familiarize

yourself with the required tools, materials, and installation

sequences. Follow the sections that pertain to your

particular installation. This will help you avoid costly

mistakes. In addition to proper installation, read all

operating and safety instructions.

All information in these instructions is based on the latest

product information available at the time of publication.

Kohler Co. reserves the right to make changes in product

characteristics, packaging, or availability at any time with-

out notice.

NOTES

 Observe all local plumbing and building codes.

 Inspect waste and supply tubing; replace if

necessary.

 If you are installing a new bath, install the drain

before installing the bath. Refer to the

manufacturer’s installation instructions.

 Adjustable pop-up drain has removable parts.

 Drain “T” is reversible for vertical or horizontal

drainage.

ORDERING INFORMATION

2” brass adjustable pop-up drain

for 24” to 26” baths K-7167. . . . . . . . . . . . . . . . . . . . . . . . .

TOOLS REQUIRED

 Assorted screwdrivers

 Adjustable or open end wrench

 Pipe wrenches

 Pliers

 Plumbers putty

ROUGHING-IN

Fig. #1

3-1/2”

3”

2” N.P.S.

2” O.D.

7”

24” BATH = 21-1/2”

26” BATH = 23-3/4”

Summary of content (4 pages)

PAGE 1
BEFORE YOU BEGIN HOW TO USE THESE INSTRUCTIONS Please read these instructions carefully to familiarize yourself with the required tools, materials, and installation sequences. Follow the sections that pertain to your particular installation. This will help you avoid costly mistakes. In addition to proper installation, read all operating and safety instructions. All information in these instructions is based on the latest product information available at the time of publication.
PAGE 2
INSTALLATION Apply a ring of plumbers putty or other sealant around underside of strainer according to the putty manufacturer’s instructions. Set flat, gasket between drain ell and the bottom of the bath. Turn strainer into drain ell. Plumbers putty Strainer Bath Gasket Drain Ell Fig. #2 Tighten drain ell securely by inserting pliers handles into top of strainer as shown. The handles will catch on bosses inside of strainer as the strainer is turned into drain ell.
PAGE 3
Tube Assemble nut and gasket on drain ell, and nut, washer and cone washer on tube. Align parts with tee as shown. Insert tubes completely into tee. Align and tighten the nuts. Washer Nuts Cone Washer Attach tailpiece to tee and tighten, Tailpiece may need to be cut for proper fit. 1” to 2” of tailpiece should fit inside the trap. Install bath according to manufacturer’s installation instructions. Make sure the tailpiece on the drain fits properly into the trap. Tee Drain Ell Gasket Fig.
PAGE 4
Insert drain stopper into drain ell. Fig. #11 Drain stopper should rise approximately 3/8” above strainer. Stopper Nut Toggle Fig. #12 If sufficient clearance cannot be obtained by adjusting stopper, remove lift rod assembly. Loosen screw and slide adjusting block up on adjusting rail to increase clearance or down to decrease clearance.