Installation Guide

2. Install the Mounting Hardware
Insert the large O-ring into the larger groove of the washer and
the small O-ring in the smaller groove of the washer.
From above the deck/rim: With the large O-ring in the washer
facing down, place the washer over the mounting hole. Insert the
supply tube assembly through the washer.
From underneath the deck/rim: Orient the tabs on the plate up.
Slide the plate onto the supply tube assembly until it is flush with
the underside of the deck/rim, then secure with the screws. Slide
the flat washer onto the supply tube assembly, then secure with
the nut.
Install the pipe plug (not shown) from the hardware kit.
Nut
Screw
Plate
Washer
Small O-Ring
Large O-Ring
Grooved Washer
Supply Tube
Kohler Co. 5 1205434-2-A