Installation Guide

1. Faucet Installation
Prepare the Site - AC and Hybrid Models
NOTE: Before drilling the mounting hole, use the following
provisions for proper placement:
A 1-1/4″ (32 mm) minimum to 1-1/2″ (38 mm) maximum
diameter mounting hole is required.
A minimum distance of 1-3/4″ (44 mm) is required between the
back of the spout and the wall to allow access to the screw.
A 1-3/4″ (44 mm) maximum distance is required between the
sink bowl edge and the base of the spout.
Install the Faucet
Determine the mounting hole location.
Drill a hole through the mounting surface according to the
surface manufacturer’s instructions.
Install the stud to the underside of the faucet.
Slide the O-ring over the flexible hoses and stud, then seat the
O-ring in the groove on the underside of the spout.
Insert the spout with flexible hoses and stud through the
mounting hole.
From under the sink, slide the rubber washer and bracket onto
the stud.
Without Escutcheon
Spout
Stud
O-Ring
Rubber Washer
Bracket
Nut
Supply Hoses
Kohler Co. 3 1124217-2-E