Instructions / Assembly

Notes
Required Electrical Service
Install this product according to the installation
instructions.
One circuit required, protected with Class A Ground-Fault
Circuit-Interrupter (GFCI) or Residual Current Device (RCD).
Connect the seat to a cold water supply of
drinking quality water at a pressure of 20 psi - 80
psi (139 kPa - 551 kPa).
120 V, 15 A, 60 Hz
Technical Information
All product dimensions are nominal.
Do not install this seat in a location where: (1)
water might be splashed on the product or (2)
ElongatedSeat shape type:
Closed-frontSeat front type:
excessive moisture, high humidity levels, or
condensation is present. This will avoid damage
to the electronic components.
5-1/2" (140 mm)Seat-mounting holes:
43" (1092 mm)Power cord length:
Do not use an extension cord with this product.
To avoid possible product malfunction, do not
plug in the seat until instructed to do so.
Locate the recepticle at least 6" (152 mm) above
the floor, and within a 32" (813 mm) radius
measured 2" (51 mm) from the bowl ledge.
USA/Canada: 1-800-4KOHLER (1-800-456-4537)
Kohler Co. reserves the right to make revisions without notice to product specifications.
For the most current Specification Sheet, go to www.kohler.com.
6-20-2018 07:54
C³
®
-455
Elongated Cleansing Toilet Seat
K-8298-CR