Installation Guide

ManualsBrandsKOHLER ManualsPlumbing Product1-1/4 in. Brass P-Trap

114233-2-AA (9626)



DRAIN SHROUD AND P-TRAPS

BEFORE YOU BEGIN

HOW TO USE THESE INSTRUCTIONS

         

       

         

      

 

NOTES

 Drain shroud conceals drain for console tables.

 Shut off the main water supply.

 Observe all local plumbing codes.

REQUIRED TOOLS AND MATERIALS

 Adjustable or open end wrench

 Strap wrench

DRAIN SHROUD INSTALLATION

Install pop-up drain per manufactures instructions.

Slide drain shroud with slot facing toward the back, up

over tailpiece and around ball lever rod, until contact with

locknut on pop-up drain.

At this point, p-trap must be installed to hold drain shroud

in position.

Tailpiece

Drain Shroud

Slot

Ball Lever Rod

P-TRAP INSTALLATIONS

K-9018 with 1-1/4” O.D. inlet, and 1-1/4” O.D. outlet.

Intended for console table installations.

Insert tube into drain outlet and connect with nut and

gasket (not supplied). Slide flange back to wall, to cover

the drain outlet.

Place trap nut and gasket onto tailpiece. Slide trap over

tailpiece and tube elbow. Tailpiece must extend 1” to 2”

into trap. Tailpiece may have to be cut to fit. Tighten nuts

and gaskets.

Cleanout plug is used to remove any debris which has

fallen into the trap.

Tailpiece

Trap

Nut

Gasket

Nut

Gasket

Flange

Tube

Drain

Outlet

Cleanout Plug

Tube

Elbow

Summary of content (2 pages)

PAGE 1
DRAIN SHROUD AND P-TRAPS BEFORE YOU BEGIN HOW TO USE THESE INSTRUCTIONS NOTES REQUIRED TOOLS AND MATERIALS Drain shroud conceals drain for console tables. Adjustable or open end wrench Shut off the main water supply.
PAGE 2
K-9020 with 1-1/4” O.D. inlet, and 1-1/4” N.P.T. outlet. Thread end of tube into drain outlet. Slide flange back to wall, to cover the drain outlet. Insert other end of tube into elbow and connect with nut and gasket. Place trap nut and gasket onto tailpiece. Slide trap over tailpiece and into elbow. Tailpiece must extend 1” to 2” into trap. Tailpiece may have to be cut to fit. Tighten nuts and gasket. Cleanout plug is used to remove any debris which has fallen into the trap.