Specification

Required Accessories
K-304-* Rite-Temp
®
valve OR ❑ NA
K-2971-KS HiFlow Rite-Temp valve with stops OR ❑ NA
K-11748-K Rite-Temp valve with diverter OR ❑ NA
K-11748-KS Rite-Temp valve with diverter and stops ❑ NA
* For a complete listing of all the Rite-Temp valves, refer to the K-304-* Specification Sheet or Roughing-In Sheet.
Optional Accessories
88526 HiFlow Rite-Temp
®
thin wall installation kit ❑ CP Other ____
1016154 Deep roughing-in kit for Rite-Temp
®
valve (lever and cross handles) ❑ CP Other ____
Installation Notes
Install this product according to the installation guide.
NOTICE: Risk of product damage. Long screws, for
installing trim, can damage the K-2971-KS valve. Consult the
trim installation guide to verify if the thin wall installation kit
(88526) is needed.
Install this product according to the installation guide.
Avoid cross-flow conditions. Do not install shut-off device on
either valve outlet.
Cap shower outlet if deck-mount spout, diverter, or
handshower is connected to spout outlet.
Install straight pipe or tube drop of 7″ (178 mm) to 18″
(457 mm) with single elbow between valve and wall-mount
spout.
Ø 4"
(102 mm)
Ø 6-1/2"
(165 mm)
1/2"-14
NPT
Ø 4"
(102 mm)
7-3/4" (197 mm)
7-3/4" (197 mm)
Lever
Handle
Cross
Handle
90˚ Bath Spout
35˚ Bath Spout
5-1/2"
(140 mm)
to Top of Rim
10-5/8"
(270 mm)
3-1/2"
(89 mm)
5-5/16"
(135 mm)
4-7/16"
(113 mm)
10" (254 mm)
to Spout
(Bath Only)
48" (1219 mm)
to Floor
(Shower Only)
72" (1829 mm)
78" (1981 mm)
to Floor (Typical)
35˚
1/2"-14
NPT
Product Diagram
PURIST
®
PURIST
®
BATH & SHOWER TRIM SET
Page2of2
1031692-4-
D