Installation Guide

3. Install the Trim
NOTE: If you are installing the K-T10423 trim, proceed to the
″Install the Trim - K-T10423″ section of this guide.
Firmly press the valve stem adapter onto the valve stem.
Secure the valve stem adapter to the valve with the correct length
screw, as selected in the ″Install the Valve Stem Adapter″ section
of this guide.
Align the holes on the front plate assembly and the valve.
Select the appropriate length screw for your application.
For a thin wall: use the 1-3/4″ (4.4 cm) screw.
For a standard wall: use the 1-3/4″ (4.4 cm) screw or the 2-1/2″
(6.4 cm) screw.
For a thick wall: use the 2-1/2″ (6.4 cm) screw.
Attach the two screws through the front plate assembly and into
the valve. Do not overtighten.
Visually inspect the front plate assembly to ensure that the foam
seal is completely covering the wall opening. If not, stop the
installation and repair the wall opening.
Place the escutcheon against the wall. The drain hole in the
escutcheon should face downward in the 6 o’clock position.
Handle Assembly
Escutcheon
Screw
Screws
Valve Stem Adapter
Front Plate
Assembly
Volume Control
Kohler Co. 5 1041505-2-J