Plumbing Product User Manual

1. Install the Mounting Stud
Disconnect the hose from the hose connector.
Screw the mounting stud into the threaded hole at the bottom of
the faucet body. The mounting stud should extend slightly
beyond the threaded hole in the body.
1. Install the Escutcheon (Optional)
NOTE: For installation on marble, do not use plumbers putty. Use
the self-adhesive gaskets provided. Remove the paper backing and
apply the gaskets (adhesive side down) over the outside holes.
For 1-hole Installations:
The escutcheon, spacer, and O-ring are not required. .Slide the
rubber washer over the faucet tubing and hose.
Insert the faucet tubing and hose into the hole.
For 3–hole Installations:
Apply a ring of plumbers putty to the underside of the
escutcheon according to the putty manufacturer’s instructions.
Insert the O-ring into the groove in the spacer.
Slide the rubber washer, escutcheon, and spacer (O-ring side
down) over the faucet tubing and hose.
Insert the faucet tubing and hose into the center hole, carefully
aligning the escutcheon.
Press down on the escutcheon and remove any excess putty.
Rubber
Washer
O-Ring
Spacer
Hose
Escutcheon
Faucet Body
Kohler Co. 3 1025494-2-B