Use and Care Manual

22
Control Box (behind front cover)
_
+
O N /O FF C LEA N M O D EA D JU ST
BIN FU LL IC E H A R V EST
Descriptions of LEDs and buttons:
1. Bin full (Red) LED: Bin Full indicator light.
When this LED is lit, the ice storage bin is full of ice or the ice-full sensor is covered with ice.
The unit will stop working.When ice cubes are taken out of the ice storage bin, clearing the
sensor, the red LED will keep flashing for 3 minutes. Then the unit will restart and return to
the ice making mode.
2. Ice Making (Green) LED: Ice Making indicator light.
When this LED is lit, the unit is working in the Ice Making mode controlled by a temperature
probe on the evaporator. When the green LED is flashing, the unit is working in the Ice Making
mode controlled by a fixed timer.
3. Ice Harvest (Yellow) LED: Ice Harvest indicator light.
When this LED is lit, the unit is working in the Ice Harvest mode controlled by a temperature
probe on the evaporator. When the yellow LED is flashing, the unit is working in the Ice
Harvest mode controlled by a fixed timer.
4. Clean button: When this button is pressed, the unit enters the Cleaning mode. The green and
yellow LEDs flash together. To stop the Cleaning mode, just press the button again.
5. Mode button: Mainly for service. When this button is pressed, unit can change from Ice
Making mode to Ice Harvest mode, or vice versa. You can judge the mode from the status of
the green and yellow LEDs.
6. Adjust button: Mainly for service. When it is pressed over 3 seconds, the unit will enter the
Ice Size Adjustment mode. The mode can be judged from the status of the yellow LED.
Ice Size Adjustment Guide:
1.) Press and hold the “Adjust” button for at least 3 seconds. The unit will enter the Ice Size
Adjustment mode. The “ICE” LED (green) will be blinking continuously during the ice size
adjustment. Release the button when the LED blinks continuously to adjust the ice size
2.) While in the Ice Size Adjustment mode, press the “Clean” (-) button or the “Mode” (+) button