Use and Care Manual

ice-cube made by the first ice making cycle after cleaning.
4. The outside of the ice maker should be cleaned regula rly with a mild detergent solution and warm
water.
5. Dry the interior and exterior with a clean soft c loth.
WATER CONNECTION FOR YOUR ICE MAKER
Important: Be sure to use the new hose-sets supplied with the appliance to
connect to water mains and that old hose-sets should not be reused.
1、Connect the water supplying hose to the unit
Step 1: First remove the clipper on the water inlet port for water supply (indicated in the
following illustration “B”) located at unit back, then pushing inward s the anti-dusty plug, use your other
hand’s finger to press the out circle to fix the anti-dusty plug, then take do w n the ant i-dusty plug; Step 2:
Insert the one end of the white water hose into the water inlet port, and push inward completely, and
install back the clipper, then water hose conne ction is completed.
2、
Connecting the water drain pipe
Pull out the water drainage cap with black color (indicated
○
A
in above illustration), then
connect the white drainage pipe included in access ory, again connect the other end of this
drainage to the main water draina ge pipeline.
3. Connect the water hose to the water faucet of the water main supply system
First, install the supplied water quick-connector to the water faucet by screw thread; Second,
remove the clipper from the water quick-connector, insert the
another end of the water hose into
this quick-connector po rt completely, then install back the clipper, also this step is completed.
Note: The water faucet should be supplied by the customer himself.
Important: The water pressure of main water supply system must be 0.04 -0.6 MPa at least.
STEP 1:Qucik-connector
and the water faucet
STEP 2:Screw the qucik-connector on the
water faucet by the screw thread, and
remove the clipper
STEP 3:Insert the water hose completely
STEP 4:Install back
the clipper
Push inwards
Remove the
clipper
STEP 1: Remove the
anti-dusty plug
Water inlet port on
the unit back
STEP 2: Insert the
water hose
Then install
back the clipper
White water
hose(accessory)
First insert the
water hose inward
completely
Remove the
clipper first
Press inward the
active out
circle,then remove
the anti-dusty plug
10