Use and Care Manual

The ice machine cleaner contains acids.
DO NOT use or mix with any other solvent-based cleaner
products.
Use rubber gloves to protect hands. Carefully read the material
safety in structions on the container of the ice machine clea ner.
DISCARD the first batch of ice troduced after cleaning.
8. Then open the water faucet of the main water supply, Let the water flow in th e unit.
Again press the
“
TIMER CLEAN
”
button on control panel for more tha n 5 seconds,
to enter the self-Cleaning program. Same as above explanation, the water pump
runs for 8 minutes and stops for 3 minutes, one cycle, again one cycle. The total
duration time is 30 minutes for one self-cleaning program .
During this process, the “CLEAN ”light will always be on d uring this period, and the
digit window will indicate the left time. Through this process, It will rinse the wa ter
dividing pipe, evaporator, water pump, silicone pipe, and water tank, etc..
9. After one self-cleaning program complete, then pull out the drain pipe of the water
tank, drain the cleaning solution down to the lower ice st orage bin, also shake the
unit slightly to drain out all of the water completely. Then install back the drain pip e
to the water tank slot tightly.
10. Repeat the step 8-9 again for 2 times.
11. Following the above program to clean
the ice storage bin .
12. Then this special cleaning program finish , you can return to the regular ice making
mode. And suggest to discard the first ba tch of ice cube.
Cleaning Suggestion
1) DAILY CLEANING
The ice shovel, door and the water dividing pipe should be cleaned by yourself per each day. At
the end of every day, rinse the ice shovel and wipe the both sides of the door with a clean cloth.
2) SEM I-MONTHLY CLEANING
The ice shovel, ice bin
, water tank, the ice-full
detecting plate and the surface of the evaporator
are to be cleaned by your self semi-monthly according to interior cleaning program.
3) SEM I-ANNUAL CLEANING
All the components & surfaces exposed to water or ice cubes, like ice storage bin, water tank, door,
evaporator, water pump, silicone tube, water dividing pipe, etc. should be cleaned
by Using
Nu-Calgon Nickle Safe Ice-machine Cleaner
per each 6 mon ths. They should be
cleaned by the serviceman according to ice making assembly system cleaning program.
18