Instructions / Assembly

kovaproducts.com Rev. 0.1 | 2020.02
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following
measures:
• Relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Pre-Installation
Tools Required (not included)
Flathead screwdriver Gloves Safety Goggles
Product Description
A - Panel Light
Product Dimensions
2 x 2 Dimensions
24 in. (605 mm)
1-3/4 in. (45 mm)
24 in. (605 mm)
2 x 4 Dimensions
47-3/4 in. (1214 mm)
1-3/4 in. (45 mm)
24 in. (605 mm)
Before You Begin
WARNING: Ensure the power is turned off at the circuit breaker or source.
Carefully remove the panel light from the packaging.
Installation
1
1. Locate all four earthquake clips (1) on the back of the panel. Twist each tab
away from the panel and test to ensure they securely sit on your T-bar ceiling
suspension system.
1
2. Rest the panel on the T-Bar (1) of your ceiling suspension system in the desired
location.
2
1
Black (Hot) Black (Hot)
Green (Ground) Green (Ground)
To Luminaire
Incoming Electrical Wires
White (Neutral) White (Neutral)
3. Remove the access plate (1) to open the connection box (2). Connect the wires
from the panel to the source wires using wire nuts as follows:
– Black to black (Live)
– White to white (Neutral)
– Green to green (Ground)
To Luminaire
Incoming Dimming Wires
Purple/Black (+)
Gray/White (-)
Purple/Black (+)
Gray/White (-)
4. For 0-10V dimming, connect the purple/black wires from the panel to the purple/
black wires from the source and the gray/white wires from the panel to the gray/
white wires from the source.
5. Ensure all wires are securely connected with wire nuts and replace the connection
box.
6. Select the CCT and wattage that you need:
– 2x2: 40W-30W-20W, 5000K-4000K-3500K
– 2x4: 50W-40W-30W, 5000K-4000K-3500K
7. Restore power at the circuit breaker or source.
Product and Warranty Information
For product and warranty information please visit kovaproducts.com.
Safety Information
WARNING: To prevent electrical shock, turn power off at the fuse box before
installation.
WARNING: To prevent wiring damage or abrasion, do not expose wiring to edges of
sheet metal or other sharp objects.
WARNING: Riskofreorelectricshock.Installationofthispanellightrequiresa
person familiar with the construction and operation of the luminaire’s
electricalsystemandthehazardinvolved.Ifnotqualied,donotattempt
installation.Contactaqualiedelectrician.
WARNING: Riskofreorelectricshock.Donotalter,relocate,orremovewiring,
lampholders, power supply, or any other electrical component.
WARNING: This product must be installed in full accordance with applicable
electrical and building codes by a person familiar with the construction
andoperationofthisxtureandallinvolvedhazards.Installationshould
beperformedbyaqualiedelectricianinaccordancewiththeNational
Electrical code and relevant local codes. Do not make or alter any open
holes in an enclosure of wiring or electrical components during installation.
CAUTION: Wearglovesandsafetyglassesatalltimeswhenremovingthexturefrom
the carton, installing, servicing, or performing maintenance.
CAUTION: Avoid direct eye exposure to the light source while it is on.
CAUTION: Do not install damaged product.
FCC Notice
CAUTION: Changesormodicationsnotexpresslyapprovedcouldvoidyourauthority
to use this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
Changesormodicationsnotexpresslyapprovedcouldvoidyourauthoritytousethis
equipment. This equipment has been tested and found to comply with the limits for a
INSTALL INSTRUCTIONS
Product
Panel Light
KPN Model Numbers
K0000019488 / K0000019489
2 x 2 Ft. Panel / 2 x 4 Ft. Panel