Owner manual

Using the PT-102VN 1:2 Video DA
5
5
5 Using the PT-102VN 1:2 Video DA
You can connect your PT-102VN:
• As a 1:2 video DA (see section
5.1)
• To a 4x1VB 4x1 High Resolution Video Switcher to increase the number of
inputs (see section
5.2)
• To two 105VB 1:5 High Resolution Video DA units to increase the number of
outputs (see section
5.3)
5.1 Connecting the PT-102VN 1:2 Video DA
To connect the PT-102VN 1:2 Video DA, as the example in
Figure 2 illustrates,
connect the following
1
1. Connect a composite video source (for example, a composite video
player) to the INPUT BNC connector.
:
2. Connect the two OUT BNC connectors to up to two composite video
acceptors, as follows:
 Connect the OUT 1 connector to video acceptor 1 (for example, a
projector)
 Connect the OUT 2 connector to video acceptor 2 (for example, a
display)
3. Connect the 12V DC power adapter to the power socket and connect the
adapter to the mains electricity.
4. If required, adjust the output signal level and/or cable compensation
equalization level.
1 Switch OFF the power on each device before connecting it to your PT-102VN. After connecting your PT-102VN, switch on
its power and then switch on the power on each device