Installation Guide

Leakage under faucet handle
Bonnet nut (11) has
come loose
Remove the cover button (15). Loosen set
screw (14) with hex wrench (22). Remove
the handle. Unscrew cap (12). Tighten
bonnet nut (11) with an adjustable wrench.
The water pressure
is low.
The connector underneath
the deck is clogged with debris
The aerator is clogged
Turn off the water supply and disconnect
the connector / aerator. Unscrew the
connector / aerator and clean under
running water. Screw the connector /
aerator back.
Test water flow. If water pressure is still low
then replace the connector / aerator.
The aerator has an
irregular or reduced
water flow
The aerator is dirty or
mis-fitted
Remove the aerator and check for debris.
Ensure that the rubber washer is properly
installed.
There is a low flow of
water.
The screen filters in the
hose connectors are dirty.
Turn off the water supply at the water
valves and unscrew the hose connectors
from the water supply lines. Clean the
screens in the water lines with hot water,
removing any debris or calcium build up.
PROBLEM CAUSE ACTION
Troubleshooting
If you have followed the instructions carefully and your faucet still does not work properly,
take the following corrective steps:
11