Installation Guide

Connect waterlines (not
included) to hot and cold
copper lines (8). Connect
waterlines (not included) to
angle stops. Tighten both
ends of waterlines with a
wrench until snug. Turn on
hot and cold angle stops
and check for leaks
Step 7: Flush spray hose
Step 8: Check for leaks
Remove spray head (1) from
spray hose (5). Hold tip of
spray hose (5). Turn faucet on
and let the water run for 60
seconds to ush any debris
Check for leaks at the
connections. Retighten if
necessary
Step 6: Connect waterlines
NOTE: Please make sure
washer (12) is installed
attaching spray head to hose
2 3 4
1 2 3
1
4 5 6 87
2 3 4
1 2 3
1
4 5 6 87
2 3 4
1 2 3
1
4 5 6 87
5
1