Owner manual

47
(SECTION SEVEN: Customizing the Phantom continued)
Infrasonic Filter
1. Use the level control knob on the preamplifier front panel or up and down keys
(14) on the remote control to select:
INFRASONIC FILTER.
2. Press the enter button or key (6) on the remote control. The front panel display
(3) shows the default mode:
OFF.
3. Use the level control knob or the up and down keys to select the desired
mode:
ON or OFF.
4. Press the enter button or key to conirm the selection. The front panel dislay
reads:
MODE.
OFF
The infrasonic filter is not engaged.
ON
The infrasonic filter is engaged, eliminating frequencies 10Hz and below from
the subwoofer outputs.
XOVER Disable
1. Use the level control knob on the preamplifier front panel or up and down keys
(14) on the remote control to select:
XOVR DISABLE.
2. Press the enter button or key (6) on the remote control. The front panel display
(3) shows the default mode:
XOVR ENABLED.
3. Use the level control knob or the up and down keys to select the desired
phase:
XOVR ENABLED or XOVR DISABLED.
4. Press the enter button or key to conirm the selection. The front panel dislay
reads:
SUBWOOFER PHASE.
XOVR ENABLED
The crossover funtionality is fully operational.
XOVR DISABLED
The crossover functionality is disabled and circuitry is removed from signal
path.
continued