Instructions / Assembly

Krosswood Doors Warranty
Variation or unsatisfactory results in sheen or texture resulting from the field application of paint, stain or lacquer or
any other finishing material or damage caused by extreme temperature.
Expansion or contraction of the door or other changes in form due to environmental conditions, including, without
limitation, changes in moisture, temperature and humidity.
Panel shrinkage or misalignment, including, without limitation, the appearance of unstained lines along the edge of a
panel (may be caused by fluctuations or differences in temperature or humidity).
Bowing or misalignment in the frame or jamb in which the door panel is hung, or problems related to water and/or air
infiltration due to improper assembly or installation.
Improper installation of hardware.
Discoloration or rusting caused by decorative metal accent options (such as grilles, clavos, straps, etc.) or hardware or
inserts (such as lock sets, door handles, strikes, etc.).
Installation of an interior door in an exterior application.
Door must be finished on all six sides.
Door installation before mudding and taping is dried and complete..
Failure to report problems with installed glass before a door is machined or finished.
Krosswood Doors is not responsible for any problems related to glass installed in a Krosswood door by a distributor or
other door shop or any Krosswood door with problems resulting from improperly installed glass. These problems
include, but are not limited to, glazing, waterproofing of glass and accompanying door cracks, blemishes, moisture in
the glass, or any injury caused by or related to glass in a door.
Acceptable characteristics include variations in color, stain, wood grain, grain appearance, unlimited tight knots and
unlimited worm holes. These variations in the product are completely normal and are not covered by this limited
warranty.
Modifying a Krosswood door will void this limited warranty. Improper modifications include, but are not limited to,
excessive trimming, removing panels, v-grooving damage (v-grooves in excess of 3/8Ǝ wide and 3/16Ǝ deep), and
distressing damage. Allowable trimming on a Krosswood door is ½” from the sides of the door and the top of the door
and 1” from the bottom of the door.
Failure to report to Krosswood Doors any visible defect or mistake in shipment more than 24 hours after receipt, or
after the product is machined or installed.
Procedures you must follow to exercise this limited warranty The integrity of a Krosswood door is predicated upon the
adherence to the following procedures. Failure to observe these procedures may result in or precipitate an adverse