User Manual

EN
FR
EN
FR
32 33
Emptying the system before a period of non-use, for frost protection or before a repair /
Vidange du système avant une période de non-utilisation, en protection contre le gel ou avant
une réparation
❻ Once emptying is done, both keys blink 3 times and the
machine turns o automatically.
Lorsque la vidange est terminée, les 2 touches
clignotent 3 fois, la machine s'éteint automatiquement.
❹ Simultaneously press the Cold Foam + Ristretto keys again.
Some steam may come out of the coee outlet and milk frother during emptying.
Appuyez simultanément sur le touches Cold Foam + Ristretto à nouveau.
De la vapeur peut sortir de la sortie café et du fouet mousseur.
❶ Insert the milk frother.Turn on the machine by pressing one
of the 9keys.
The milk frother must be inserted before starting the
procedure.
Mettez en place le fouet mousseur. Allumez la machine en
appuyant sur l’une des 9 touches.
Le fouet mousseur doit être mis en place avant de
commencer la procédure.
❷ Remove the water tank. Lift the lever to eject the capsule.
Leave the lever open. Place a container (600 ml) under the
head.
Retirez le réservoir d’eau. Levez le levier pour éjecter la
capsule. Laissez le levier ouvert. Placez un récipient (600 ml)
sous la tête.
3 sec.
❸ Simultaneously press the Cold Foam + Ristretto keys for 3
seconds: both keys blink.
Appuyez simultanément sur les touches Cold Foam +
Ristretto pendant 3 secondes : les 2 touches clignotent.
❺ The keys blink softly and emptying is underway.
Les touches clignotent doucement et la vidange est en cours.
❼ Close the lever. Remove the container, milk frother, drip tray,
capsule container and drip base. Clean them.
Abaissez le levier. Enlevez le récipient, le fouet mousseur, le
bac d'égouttage, le bac de récupération d'eau et le bac à
capsules. Nettoyez-les.
Troubleshooting
Videos are available via the Nespresso Mobile Application and on www.nespresso.com – Consult the "Services” section.
No light on the keys and indicator lights. - Check the outlet, plug, voltage and fuse.
- Turn on the machine by pressing one of the 9
keys.
- If the problem persists, call Nespresso.
The "Descaling" alert blinks orange and the milk-
based drinks keys work.
-
Descaling is required: a few cycles remain
before your machine locks itself. Descale the
machine.
When you press the recipe key, it does not start
and the "Descaling" alert, Lungo and Ristretto
keys blink.
-
The machine is in safety mode against scale;
use is blocked. Descale the machine; refer to the
"Descaling" paragraph.
During descaling, the Lungo + Ristretto keys blink
and the "Descaling" indicator light remains lit.
-
Your water tank is empty, but the descaling
cycle is not completed. Rinse the water tank and
completely fill it with fresh drinking water. Press
the Lungo + Ristretto keys to resume the cycle.
The 9 keys blink quickly non-stop. -
The water tank is empty. Several recipes in a row
were launched with no water in the water tank;
the priming mode will be launched after pressing
any key. Pour water in the water tank. Place the
milk frother and a container under the head.
Press any key. Take care, some water and steam
will flow out from the milk frother connection for
a few seconds. If you have lost the milk frother,
Press and hold Espresso and Iced frappé keys
during 3 seconds.
The recipe key blinks rapidly during preparation. - The water tank is empty. Fill the water tank.
The milk foam is insucient. -
Use refrigerated skimmed or semi-skimmed milk
(approximately 4° C).
- Rinse the milk frother after each preparation.
-
Descale the machine (see the "Descaling"
paragraph).
-
Refer to the paragraph "Milk recipe
preparations".
- Correctly center the cup relative to the machine.
- Clean the milk frother connection.
Milk-based recipes keys do not light up. - Set up the milk frother so that all keys light up.
Milk overflows from the mug during preparation. - Refer to "Milk recipe preparations" paragraph
prior to making milk-based preparations to
adjust the quantity of milk or to choose a more
suitable mug.
The "Clean" alert is a steady orange light. - Remove the milk frother. Rinse it.
The lever does not fully close. -
Empty the capsule container. Ensure that there are
no capsules blocked in the capsule container.
Leakage around the capsule (water present in the
capsule container).
-
Properly insert the capsules. In the event of a
leak, call Nespresso.
No coee, no water. - The water tank is empty: fill it.
-
Descale if necessary, see the "Descaling"
paragraph.
The coee flows very slowly. - The flow rate depends on the capsule type.
-
Descale if necessary, see the "Descaling"
paragraph.
No coee, only water is flowing (despite having
inserted a capsule).
- Call Nespresso.
The coee is not hot enough. - Preheat the cup.
- Perform a rinse of the machine.
-
Descale if necessary, see the "Descaling"
paragraph.
Cannot go to the Menu Mode (e.g. "Descaling"
"Automatic Power Saving Setting").
- Turn on the machine.
-
Ensure that you simultaneously press the keys
for 3 seconds.
- Plug/unplug the machine.
- If the problem persists, call Nespresso.
Irregular blinking. -
Send the machine to the repair center or call
Nespresso.
The 9 keys blink simultaneously for 10 seconds
and the machine turns o.
-
Breakdown Alarm: Arrange to have the machine
repaired or call Nespresso.