User manual

User Manual of Network Video RecorderKVR-p16Px16 & KVR-p32Px16
201
14.4 Configuring More Settings for Device Parameters
Steps:
1. Enter the General Settings interface.
Menu >Configuration>General
2. Click the More Settings tab to enter the More Settings interface, as shown in Figure 14. 4.
Figure 14. 4 More Settings Interface
3. Configure the following settings:
• Device Name: Edit the name of NVR.
• Device No.: Edit the serial number of NVR. The Device No. can be set in the range of 1~255, and the
default No. is 255. The number is used for the remote and keyboard control.
• CVBS Output Brightness: Adjust the video output brightness.
• Auto Logout: Set timeout time for menu inactivity. E.g., when the timeout time is set to 5 Minutes, then
the system will exit from the current operation menu to live view screen after 5 minutes of menu
inactivity.
• Enable HDMI/VGA Simultaneous Output: By default, the video outputs from HDMI and VGA
interfaces can be operated separately. You can set the simultaneous output for the HDMI and VGA by
checking the checkbox of the option. By unchecking this box, you may use the HDMI and VGA
monitors independently, to display different live views, or to display live video on one monitor and
playback on the other, etc. CVBS can also be configured as an independent ‘call’ monitor
• Menu Output Mode: You can choose the menu display on different video output. There are auto,
HDMI, VGA and Main CVBS selectable.
4. Click the Apply button to save the settings.