Owner manual

190
NOTE
Please note that this device has the same function as HD-SDI repeater that extends the signal transmission distance up to
150m.
13.8 HFO1100 & HFO1200
13.8.1 Introduction
 HFO 1100 Series are HD-SDI/Fiber optic converters which enable the transmission of HD-SDI signal up to 30km. These
converters meet SMPTE 292M specification and are suitable for both indoor and outdoor use. HFO1200 receives the HD-SDI
signal and send the signal out through fiber optic cable. HFO 1100 receives the signal from fiber optic cable and send it out
through HD-SDI coaxial cable.
13.8.2 Features
 Transmission of HD-SDI over Single Mode Optical Fiber
 Auto-detection of Video Format
 HD-SDI Connector (SMPTE292M)
 LC Fiber Optic Connector
 Low Power Consumption: Free Voltage 12VDC, 1A
 Input / Output Return Loss : > -15dB at 1.5GBPS
 Input / Output Impedance : 75 Ohms +/- 1%
 All inputs, either SDI or Fiber, are equalized and re-clocked
13.8.3 Technical Specification
Model HFO1100 HFO1200
Format 3 Gb, 1.5Gb, 270Mb Auto Detect
Video Inputs 1 LC Fiber Optic Connector 1 HD-SDI Input(SMPTE 292M)
Input Format
1080p 24/25/30
1080i 50/60
720p 24/25/30/50/60
Video Outputs 1HD-SDI Output(SMPTE 292M) 1 LC Fiber Optic Connector
Output Format
1080p 24/25/30
1080i 50/60
720p 24/25/30/50/60
Cable Equalization
(BNC Inputs, 1694 Coax)
270mb, 460m
1.5Gb, 230m
3Gb, 150m
Input Return Loss(BNC) >-15dB, 270Mb-3Gb
Output Return Loss(BNC) >-15dB,270Mb-3Gb
Input Impedance 75Ohms+/-1%
Output Impedance(BNC) 75Ohms+/-1%
Optical Outputs
Wavelength:13 10nm
Output Power:-2dBm Typical
Power Consumption Free Voltage 12VDC, 1A
Dimension (W*H*D) 83.75mm x 31.75mm x 87.07mm / 3.35kinch x 1.27inch
13.8.4 Unpacking
 This equipment is an electronic appliance, so it should be handled with special care.
13.8.5 Service
 If there is any problem in the product, please contact the supplier or the distributor.