Owner manual

 Check  Beep: When Bad detects from HDDs, it will give the alarm sound.

 Check  Message: When Bad detects from HDDs, the alarm message will pop up on the OSD.

NOTE

When “Attention or Warning” is detected by S.M.A.R.T, notification (Alarm out, Email, Beep and Message) will not activate.

 Click ( ) Overwrite and the following screen will display.

Overwrite Setting

 Click ( ) Overwrite box and users may activate the overwrite function. (Overwriting mode is default)

- This function makes restart the recording from the beginning when the HDD is full. The previous recorded data will be

erased from the first one. Following icon will display in bottom of live mode.

 A user shall designate the total recording days from 1 day to 90 days and unlimited.

 Click ( ) Stop recording box and users may deactivate the overwrite function.

- Recording will stop automatically when the HDD is full.

- At no Overwrite mode, will display while the recording is going on.

Notification

 Users may set the certain value of HDD usage for notification. It will notify, when free space in HDD is less than the specified

value. The values are from 0 ~ 100%

 Check  Alarm out: users can set the alarm out, when free space in HDD is less than the specified value. If Click ( ) ‘All’, all

items are check/uncheck at once.

 Check  E-mail: users can receive the email notification to registered email address, when free space in HDD is less than the

specified value. If Click ( ) ‘All’, all items are check/uncheck at once.

 Check  Beep: a DVR makes beeping sound when free space in HDD is less than the specified value.

 Check  Message: the warning message “Free space in HDD is less than (xx%)!” will display on the OSD

CAUTION

IF USERS USE “Recording Days” FUNCTION, DVR WILL STORE ONLY THE DAYS THAT SPECIFIED BY USERS AND

STOPS RECORDING. PLEASE BEWARE OF DATA LOSS DUE TO “Rec Days” FUNCTION.

NOTE

Notify setting does not affect saving the recorded data. It only gives notification and keep recording until hard disk is full.

NOTE

For more specific setting about Alarm-out, use Setup>DEVICE>ALARM>Alarm Out.

Overwrite