Corp. Mixer User Manual

3000STOPR005810R082503

HAY MAXX SYSTEM adjustments

Basic HAY MAXX SYSTEM must be bolted in the fully extended upright position if not equipped with

optional hydraulic cylinder.

HAY MAXX SYSTEM equipped with optional hydraulic cylinder can be adjusted with the clevis on the

cylinder so that when the cylinder is fully extended the pan is in the upright position and when the cylinder

is retracted the pan is completely down.

Adjusting the knife to pan tolerance may be necessary for different types of feedstuff. As hay may vary

in quality, moisture and material, each of these can affect how it goes through the HAY MAXX system.

The pan can be adjusted to up to 1” from the knife for a more aggressive faster take through and will greatly

increase the power required to operate. The factory setting is at 1/2”- 5/8” and should never be adjusted to

less than 1/2” apart or greater than 1”. Field testing shows that 1/2” -5/8” is best for most materials.

To adjust: loosen bolts, 3 in front & 2 at rear at the locations shown, make adjustment then securely tighten

all five bolts.

INSPECTION & ADJUSTMENTS

ALWAYS STOP MIXER AND LOCK OUT POWER BEFORE SERVICING, REPAIRING, OR CLEANING.

IF WORK MUST BE PERFORMED INSIDE THE MIXER, STOP MIXER AND LOCK OUT POWER AND

PUT A PROTECTIVE COVER OVER THE AUGER KNIVES TO AVOID INJURY. THE HOPPER FLOOR

MAY BE SLIPPERY, AND THE REEL AND AUGERS WILL SPIN WHEN STEPPED ON. USE CAUTION

WHEN STEPPING OR STANDING INSIDE THE UNIT. USE SAFE SHOP PROCEDURES AND EXERCISE

CAUTION WHEN WORKING ON THIS MIXER!